Show Arp - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

14.1.10 show arp

This command displays the ARP cache. The displayed results are not the total ARP
entries. To view the total ARP entries, combine the
results.
switch
Format
Mode
Age Time
(seconds)
Response Time
(seconds)
Retries
Cache Size
Dynamic Renew
Mode
Total Entry Count
Current / Peak
Static Entry Count
Current / Max
The following fields are displayed for each ARP entry.
IP Address
MAC Address
Interface
Type
Age
Routing Commands
show arp
Privileged EXEC
Is the time it takes for an ARP entry to age out. This value
was configured into the unit. Age time is measured in sec-
onds.
Is the time it takes for an ARP request timeout. This value
was configured into the unit. Response time is measured in
seconds.
Is the maximum number of times an ARP request is retried.
This value was configured into the unit.
Is the maximum number of entries in the ARP table. This
value was configured into the unit.
Displays whether the ARP component automatically attempts
to renew dynamic ARP entries when they age out.
Field listing the total entries in the ARP table and the peak
entry count in the ARP table.
Field listing the static entry count in the ARP table and maxi-
mum static entry count in the ARP table.
Is the IP address of a device on a subnet attached to an exist-
ing routing interface.
Is the hardware MAC address of that device.
Is the routing unit/slot/port associated with the device ARP
entry.
Is the type that was configured into the unit. The possible val-
ues are Local, Gateway, Dynamic and Static.
This field displays the current age of the ARP entry since last
refresh (in hh:mm:ss format
v4.1, October 2008
results and the
show arp show arp
14-5