Clear Arp-Cache; Show Arp - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

14.1.9 clear arp-cache

This command causes all ARP entries of type dynamic to be removed from the ARP
cache. If the gateway parameter is specified, the dynamic entries of type gateway are
purged as well.
Format
Mode

14.1.10 show arp

This command displays the ARP cache. The displayed results are not the total ARP
entries. To view the total ARP entries, combine the
results.
switch
Format
Mode
Age Time
(seconds)
Response Time
(seconds)
Retries
Cache Size
Dynamic Renew
Mode
Total Entry Count
Current / Peak
Static Entry Count
Current / Max
14-6
clear arp-cache [gateway]
Privileged EXEC
show arp
Privileged EXEC
Is the time it takes for an ARP entry to age out. This value
was configured into the unit. Age time is measured in sec-
onds.
Is the time it takes for an ARP request timeout. This value
was configured into the unit. Response time is measured in
seconds.
Is the maximum number of times an ARP request is retried.
This value was configured into the unit.
Is the maximum number of entries in the ARP table. This
value was configured into the unit.
Displays whether the ARP component automatically attempts
to renew dynamic ARP entries when they age out.
Field listing the total entries in the ARP table and the peak
entry count in the ARP table.
Field listing the static entry count in the ARP table and maxi-
mum static entry count in the ARP table.
v1.0, December 2005
results and the
show arp
Routing Commands
show arp