Show Mac-Address-Table Static - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Format
Mode
MAC Address
Type
Component
Description
Interfaces
Forwarding
Interfaces

4.4.11 show mac-address-table static

This command displays the Static MAC Filtering information for all Static MAC Filters. If
you select
<all>
value for
<macaddr>,
Static MAC Filter information only for that MAC address and VLAN.
Format
Mode
MAC Address
VLAN ID
Source Port(s)
Destination
Port(s)
Port and System Setup Commands
show mac-address-table multicast <macaddr>
Privileged EXEC
A multicast MAC address for which the switch has forward-
ing and or filtering information. The format is two-digit hexa-
decimal numbers separated by colons, for example
01:23:45:67:89:AB. In an IVL system the MAC address will
be displayed as a MAC address and VLAN ID combination
of 8 bytes.
This displays the type of the entry. Static entries are those that
are configured by the end user. Dynamic entries are added to
the table as a result of a learning process or protocol.
The component that is responsible for this entry in the Multi-
cast Forwarding Database. Possible values are IGMP Snoop-
ing, GMRP, and Static Filtering.
The text description of this multicast table entry.
The list of interfaces that are designated for forwarding
(Fwd:) and filtering (Flt:).
The resultant forwarding list is derived from combining all
the component's forwarding interfaces and removing the
interfaces that are listed as the static filtering interfaces.
, all the Static MAC Filters in the system are displayed. If you supply a
you must also enter a value for
show mac-address-table static {<macaddr> <vlanid>
| all}
Privileged EXEC
Is the MAC Address of the static MAC filter entry.
Is the VLAN ID of the static MAC filter entry.
Indicates the source port filter set's slot and port(s).
Indicates the destination port filter set's slot and port(s).
v1.0, March 2006
, and the system displays
<vlanid>
4-19