Polycom MGC Administrator Administrator's Manual page 101

3. Click one of the following options to set up the clock source for the
system.
Table 3-12: Net-2/Net-4/Net-8 Unit Configuration Options
Option
Set as Primary
Clock Source
Cancel Primary
Clock Source
Set As Backup
Clock Source
Cancel Backup
Clock Source
After setting the clock source, a Warning message box opens, instructing
you to reset your MCU.
The configuration changes take effect only after the next MCU reset or
start up, and they are shown in the Configured Clock column in the Status
pane.
Description
Sets this unit as the primary clock source. For
further information, see Chapter 5, "Clocking" on
page 5-132.
Stops this unit from acting as the primary clock
source. For further information, see Chapter 5,
"Clocking" on page 5-132.
Sets this unit as the backup clock source. For
further information, see Chapter 5, "Clocking" on
page 5-132.
Stops this unit from acting as the backup clock
source. For further information, see Chapter 5,
"Clocking" on page 5-132.
MGC Administrator's Guide
3-51