Polycom MGC Administrator Administrator's Manual page 3

Canadian Department of Communications (EC) Declaration of Conformity
Polycom, Inc. declares that the MGC-50/MGC-100 with NET-8 card is in conformity with the following relevant harmonized
standards:
EN 60950: 1992 Including Amendments 1,2,3 & 4
EN 55022: 1994
EN 50082: 1997
and follows the provisions of the Council Directive 1999/EC on radio and telecommunication terminal equipment and the
recognition of its conformity.
Notice: The Industry Canada label identifies certified equipment. This certification means that the equipment meets
telecommunication network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment
Technical Requirements document(s). The Department does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer
should be aware that compliance with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment malfunctions, may give the telecommunications company cause to request the user to disconnect
the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and
internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural
areas.
Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection
authority, or electrician, as appropriate.