Polycom MGC Administrator Administrator's Manual page 302

Chapter 5 - MCU System Management
5-66
Section GENERAL
SECURED_PORT_MANDATORY_FOR_API = NO
•
When set to YES, API connection is only allowed via SSL secured
connection.
SECURED_PORT_MANDATORY_FOR FILE = NO
•
When set to YES, file transfer is only allowed via SSL secured
connection.
• PREFERRED_SECURED_PORT = 443
When mandatory security is enabled from the MGC manager, on first
connection after the reset, MCU will automatically use only the preferred
SSL-secured port 443, and the HTTPS protocol./
TRADITIONAL_END_POINTS_MODE = YES
•
When set to YES, enables support for old endpoints like Swiftsite.
CDR = YES
•
When set to YES, enables the use of the CDR on the system.
PRODUCT_TYPE = 100
•
Defines the type of MCU used as a system, the default being set to the
MGC-100. Selection of three types is possible: MGC-100 (= 100),
MGC-50 (= 50) and MGC-25 (= 25).
• H0 = NO
Enables H0 network connectivity.
IGNORE_AIM = YES
•
When set to YES, allows the participant to use an external telephone,
while the endpoint's audio channel is muted, however, the participant's
audio channel status is indicated by the "Mute by Endpoint" icon in the
MGC Manager Monitor and Status panes. Also, when the participant is
muted from the endpoint, the participant can use an external telephone to
connect to the conference while the endpoint's audio channel is muted.
• HIGH_BIT_RATE = YES
Setting the High Bit Rate flag to YES enables Continuous Presence and
Transcoding conferences to be run at up to 1920 Kbps on the standard
Video cards. This option should be selected only if all the video cards are
of the new version. If the High Bit Rate flag is set to YES and the MCU
contains video cards of a version older than 1.43, the MCU's status