Faults Alert - Polycom MGC Administrator Administrator's Manual

MGC Administrator's Guide

Faults Alert

You can set the operator workstation to beep continuously whenever a fault is
detected. The system stops beeping only once the fault is corrected. By
default, this option is disabled.
To enable continuous beeping whenever a fault exists:
On the Options menu, click Beep on faults.
To check whether the option is currently active, open the Options menu, and
verify that a check mark appears next to the Beep on faults menu item.
In this case, the feature is currently enabled. If there is no check mark next to
the Beep on faults menu item, the feature is disabled.
5-139