Polycom MGC Administrator Administrator's Manual page 460

Chapter 7 - Configuring the Gateway
7-52
Table 7-7: Address Book - Endpoint Definition Options (Continued)
Field
DID Number
Destination
Endpoint Type
H.320 Endpoint
Parameters
H.323 Endpoint
Parameters
Description
Displays the Direct Inward Dialing (DID) number
assigned to this endpoint during the H.320 Routing
Service definition. When using H.320 services, the
DID number is used to identify the destination
endpoint in the Address Book table. This number
cannot be changed in this dialog box and is for
display purposes only.
Select whether the destination Endpoint is an H.320
or H.323 endpoint.
According to the selected type, the appropriate H.320
or H.323 endpoint parameters are enabled and the
default Network Service Session Profile is displayed.
Enter the ISDN number to reach the endpoint. The
number must be exactly as the MCU needs to dial it.
These fields are only applicable if you chose an
H.320 Endpoint
Phone number - The H.320 endpoint phone number.
Bonding phone - The bonding number used for
aggregated channels.
Enter the information required to reach the endpoint.
These fields are only applicable if you chose an
H.323 Endpoint.
Alias Type - The format of the endpoint Alias Name
(H.323 ID and E.164).
Alias Name - The Endpoint Alias according to the
Alias Type.
Note: Enter the Alias Name using the naming
conventions appropriate to the selected
Alias Type.
IP Address - IP address of the H.323 endpoint.