Polycom MGC Administrator Administrator's Manual page 305

CASCADE_TO_PREVIOUS_VERSION = 0
•
When set to 0 you are not able to Cascade conferences with previous
MCU software versions. Set to the version number (or earlier) to which
cascading is to be enabled.
CP_REGARD_TO_INCOMING_SETUP_RATE = YES
•
When set to YES in a Continuous Presence mode, the MCU checks the
Bandwidth requested by the endpoint, if the participant is not connected
(only when the participant has capabilities of the defined conference
rate).
• SOFTWARE_CP = YES
This option enables Software Continuous Presence conferences.
IGNORE_STREAM_VIOLATION = NO
•
Normally when RTP encounters severe problems in the media streams, it
sends STREAM_STATUS_IND to mcms, and as a result mcms moves
the sender into Secondary. If this is done in the Nortel environment the
agent always be secondary because it always sends overflow. This flag is
used to ignore this indication from the card for any state of the call
except change mode.
• IGNORE_STREAM_VIOLATION_IN_CHANGE_MODE = NO
Normally when RTP encounters severe problems in the media streams, it
sends STREAM_STATUS_IND to mcms, and as a result mcms moves
the sender into Secondary. If this is done in the Nortel environment the
agent always be secondary because it always sends overflow. This flag is
used to ignore this indication from the card for change mode.
THRESHOLD_BITRATE=100
•
Determines the acceptable deviation, in percentage, from the expected
channel bitrate as declared and negotiated between the MCU and the
endpoint (in the H.245 channel). The threshold is defined in fractions of
1000, therefore, a threshold of 100 defines 10%. Entering zero for a flag
disables the flag.
• THRESHOLD_FRACTION_LOSS=5
Determines the acceptable percentage of the channel Fraction Loss (as it
appears in the Channel Status box). The threshold is defined in fractions
of 1000, therefore, a threshold of 100 defines 10%. Entering zero
disables the flag.
MGC Administrator's Guide
5-69