System.cfg Flags - Polycom MGC Administrator Administrator's Manual

System.cfg Flags

Only those flags which are intended for customer modification are documented
here.
Section TRACE OUTPUT
PRINT = IP
•
Defines the port to be used for Serial Traces.
The flag may be set to one of the following values:
— Console - Trace to the Console.
— Serial_1 - on the back (Also of the MGC-25).
— Serial_2 - front (Not applicable for the MGC-25).
— IP
TRACE = EXCEPTION
•
Default Tracing level.
This flag may be set to one of the following values:
— NO- no trace
— INTERACTIVE - level –I (accept input from terminal without
dumping to trace)
— EXCEPTION- level –e Asserts, memory exceptions
— INTO_MCMS_TRACE - level –g (embedded to mcms information)
— T120 - level –t GCC Trace
— FULL - full information
Section LOGGER TRACE
TRACE_LOGGER_APPLICATION = YES
•
Use this flag to enable (YES) or disable (NO) the Logger Utility.
TRACE_LOGGER_LEVEL = INTO_MCMS
•
Indicates the detail level of messages to be saved to the Logger file.
(INTO_MCMS, EXCEPTION, FULL)
MGC Administrator's Guide
5-61