Fault Category - Assert; Fault Category - Startup - Polycom MGC Administrator Administrator's Manual

Fault Category - Assert

Fault Category - Startup

Table A-6: General Fault Descriptions (Continued)
Code
_
UNEXPECTED HARDWARE
VERSION
!!!
UNKNOWN
_ _
VERSION DOSNT MATCH
_ _
WRONG DONGLE
ATTACHED
Table A-7: Assert Fault Descriptions
Code
_ _
SOFTWARE ASSERT FAILURE
Table A-8: Startup Fault Descriptions
Code
SYSTEM STARTUP
Level Description
_ major Card version does not match
"card.cfg". This situation can occur if a
card of the same type but of a different
hardware version is replaced while the
MCU is off.
major An inconsistent MGC Manager version
is being used.
major Version number in the arrow
configuration is less than 5.
major When an inconsistent dongle is
attached to the MGC.
Level Description
major A program assertion has failed. This
indicates an error in the program
execution. If this problem persists,
consult your service engineer.
Level Description
startup This message is generated each
time the system is booted.
MGC Administrator's Guide
A-13