Polycom MGC Administrator Administrator's Manual page 324

Chapter 5 - MCU System Management
5-88
NUMBER_OF_DIGITS = 9
•
When using ISDN Overlap sending dialing mode, this field holds the
number of digits to be received by the MCU.
NET8_DEFAULT_TYPE = ISDN or T1-CAS
•
This flag is required to select the default network type, as it is not
possible to mix an ISDN Network Service and a T1-CAS on the same
Net-2/Net-4/Net-8 Network Interface card.
• SILENT_CHNL_TS = 127
Silent TS for idle pattern (0-127) for T1CAS. TS is TimeSlot. 1 TDM
has 128 TS on it.
SILENT_CHNL_LINE = 15
•
Silent TDM for idle pattern (0-15) for T1CAS.
MIN_TX_WINK = 20
•
For T1-CAS, minimum time (in msec) to transmit Wink after receiving
Setup. Possible values 0 to 255.
MAX_TX_WINK = 29
•
For T1-CAS, maximum time (in msec) to transmit Wink after receiving
Setup. Possible values 0 to 255.
• SETTLING_TIME = 4
For T1-CAS. DIAL OUT- end of DTMF sending till expected reception
of tones. Possible values 0 to 255.
NO_ASNWER_TONE = 40
•
For T1-CAS. Disconnection time-out (in sec.) in case of no answer or no
tone. Possible values 0 to 255.
MIN_RX_WINK = 10
•
For T1-CAS, minimum time (in msec) to receive Wink after sending
Setup. Possible values 0 to 255.
• MAX_RX_WINK = 35
For T1-CAS, maximum time (in msec) to receive Wink after sending
Setup. Possible values 0 to 255.
• PARTIAL_DIAL_TO = 10
For T1-CAS. In DIAL IN-How long (in sec) do we wait to the next digit
till we decide that this is a partial dialing and therefore an unsuccessful
dial in call and resources can be freed. Possible values 0 to 255.