Polycom MGC Administrator Administrator's Manual page 308

Chapter 5 - MCU System Management
5-72
ARQ_WHEN_CALL_IS_WITH_IP = YES
•
When a card is registered with a Gatekeeper, and the participant has a IP
address (not alias), an ARQ message is sent to the Gatekeeper.
RRQ_WITHOUT_GRQ = NO
•
Must be set to NO for the register as a gateway feature to function
properly.
YES – Registration start with RRQ (Registration Request).
NO – Registration start with GRQ – Gatekeepers Request)
• MCU_REG_AS_320_GW = YES
When working in register as GW mode two options are available,
H320_GW (YES), or H323_GW (NO). When working with CISCO
MCM it is require to register as H320_GW (YES)
H323_ENABLE_CONFERENCE_DIALIN_IDENTIFY = NO
•
Set the flag to YES to enable the enhanced cascading mode in which
Aliases (conference name and participant name) may be used for H.323
cascading conferences.
PATH_NAVIGATOR_OLD_VERSION_IN_ROUTED_MODE = NO
•
When set to YES the MCU does remove People+Content or Duo Video.
• REMOVE_G722_AND_GENERIC_AUDIO = NO
If set to YES a VOIP phone cannot always establish a connection when
using PathNavigator as the Gatekeeper.
• ENABLE_ALT_GK = YES
YES - Enables use of the alternate gatekeeper when the primary
gatekeeper fails.
NO - Disables use of the alternate gatekeeper.
Section IP MEDIA FLAGS
IP_AUDIO_CONCEALMENT = NO
•
Because of RTP demand this flag is used to set the G711 to 30 FPP.
• SIP_G711_FPP = 30
Enables you change the frame per packet of audio algorithm G.711.
SIP_G7231_FPP = 30
•
Enables you change the frame per packet of audio algorithm G.723.1.