Polycom MGC Administrator Administrator's Manual page 546

Appendix D: The Falcon Diagnostic Tool
D-4
Table D-1: Diagnostic Tests (Continued)
Card Unit
IPN NET-2
(MGC-25
only)
Proc
Test Description
ISDN- The Falcon diagnostic tool
Loopback displays the NET-2 card as a unit
in the IPN card. This test checks
the ISDN hardware. To run this
test, an ISDN Loopback cable
must be connected to the
Network I/O card. For more
details, see "Connecting the LAN
and ISDN Loopback cables" on
page D-15.
Clock Checks the frequency rate of the
processor
Local memory Checks buses' data and
addresses.
Checks memory integrity and
capacity.
Neighbor Checks the PCI access between
processors.
LAN This test requires that a LAN
cable be connected to the I/O of
the card. See "Connecting the
LAN and ISDN Loopback cables"
on page D-15. Checks the ping
between the card and the Falcon
host machine IP Address.
TDM Creates a loop between the DSP
through the backplane and back
to the DSP to check data transfer
through the loop.
Full memory Checks all the processing
memory of the card manager.