NEC UPD703116 User Manual page 813

Page
Addition of 9.1.5 (4) [Output waveform width in respect to set value] (d) When BFCMnx = 0000H is set
p. 281
while DTMnx = 000H or TM0CEDn bit = 1
Addition of 9.1.5 (4) [Output waveform width in respect to set value] (e) When BFCMnx = CM0n3 = a is
p. 282
set
Addition of Caution to 9.2.3 (1) Timers 10, 11 (TM10, TM11)
p. 297
p. 299 Deletion of Note and modification of description in 9.2.4 (1) Timer 1/timer 2 clock selection register
(PRM02)
Modification of description in table in 9.2.4 (6) (b) UDC mode (CMD bit of TUMn register = 1)
p. 307
Modification of description in Table 9-7 List of Count Operations in UDC Mode
p. 316
Deletion of Note and modification of description in 9.3.4 (1) Timer 1/timer 2 clock selection register
p. 335
(PRM02)
p. 337 Modification of description in 9.3.4 (3) Timer 2 count clock/control edge selection register 0 (CSE0)
Addition of 9.3.4 (6) (a) Caution for PWM output change timing
p. 342
Addition of Remark to Figure 10-1 Asynchronous Serial Interface 0 Block Diagram
p. 413
Deletion of a part of description and addition of Caution to 10.2.3 (2) Asynchronous serial interface status
p. 417
register 0 (ASIS0)
Addition of description to 10.2.6 (5) Transfer rate during continuous transmission
p. 441
Addition of description to 10.2.7 Precautions (2)
p. 441
Modification of Figure 10-19 Asynchronous Serial Interface Reception Completion Interrupt Timing
p. 461
Modification of description in 11.10 (11) CAN global interrupt pending register (CGINTP)
p. 562
Modification of description in 11.10 (12) CAN1 interrupt pending register (C1INTP)
p. 563
Addition of Caution to 14.5.2 (1) Timer 10 noise elimination time selection register (NRC10)
p. 714
Addition of Caution to 14.5.2 (2) Timer 11 noise elimination time selection register (NRC11)
p. 714
Addition of Caution to 14.5.2 (3) Timer 3 noise elimination time selection register (NRC3)
p. 715
Addition of Caution to 14.5.3 (1) Timer 2 input filter mode registers 0 to 5 (FEM0 to FEM5)
p. 717
Addition of (2) to Table 20-1 Surface Mounting Type Soldering Conditions
p. 790
p. 784 in previous Deletion of APPENDIX A NOTES
edition
APPENDIX D REVISION HISTORY
Description
User's Manual U14492EJ5V0UD
(2/2)
813