Related commands
prefix-suppression
ospfv3 primary-path-detect bfd
Use
ospfv3 primary-path-detect bfd
Use
undo ospfv3 primary-path-detect bfd
Syntax
ospfv3 primary-path-detect bfd { ctrl | echo } [ instance instance-id ]
undo ospfv3 primary-path-detect bfd [ instance instance-id ]
Default
BFD is disabled for OSPFv3 FRR.
Views
Interface view
Predefined user roles
network-admin
Parameters
: Enables BFD control packet mode.
ctrl
: Enables BFD echo packet mode.
echo
instance instance-id
Usage guidelines
This command enables OSPFv3 FRR to use BFD to detect primary link failures.
Examples
# On VLAN-interface 10, enable BFD echo packet mode for OSPFv3 FRR.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] fast-reroute lfa
[Sysname-ospfv3-1] quit
[Sysname] bfd echo-source-ipv6 1::1
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 primary-path-detect bfd echo
ospfv3 timer dead
Use
ospfv3 timer dead
Use
undo ospfv3 timer dead
Syntax
ospfv3 timer dead seconds [ instance instance-id ]
undo ospfv3 timer dead [ instance instance-id ]
to enable BFD for OSPFv3 FRR.
: Specifies an instance by its ID in the range of 0 to 255. The default is 0.
to set the OSPFv3 neighbor dead time.
to remove the configuration.
72
to disable BFD for OSPFv3 FRR.