H3C IE4300 Command Reference Manual page 1603

Parameters
ipv6-address
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command.
Examples
# In VLAN 2, enable MLD snooping, and specify FE80:0:0:1::1 as the source IPv6 address for MLD
general queries.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping general-query source-ip fe80:0:0:1::1
Related commands
enable (MLD-snooping view)
mld-snooping enable
mld-snooping group-limit
Use
mld-snooping group-limit
port can join.
Use
undo mld-snooping group-limit
multicast groups that a port can join.
Syntax
mld-snooping group-limit limit [ vlan vlan-list ]
undo mld-snooping group-limit [ vlan vlan-list ]
Default
No limit is placed on the maximum number of IPv6 multicast groups that a port can join.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
: Specifies the maximum number of multicast groups that a port can join, in the range of 0 to
limit
4294967295.
vlan vlan-list
VLAN by its ID or a range of VLANs in the form of
ID is in the range of 1 to 4094. If you do not specify a VLAN, this command takes effect for all VLANs.
Usage guidelines
This command takes effect only on the IPv6 multicast groups that a port joins dynamically.
: Specifies the source IPv6 address for MLD general queries.
: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a
to set the maximum number of IPv6 multicast groups that a
to remove the limit on the maximum number of IPv6
start-vlan-id to end-vlan-id
31
. The VLAN