H3C IE4300 Command Reference Manual page 1607

source-ip ipv6-source-address
you specify an IPv6 multicast source, this command configures the port as a simulated member host
for an IPv6 multicast source and group. If you do not specify an IPv6 multicast source, this command
configures the port as a simulated member host for an IPv6 multicast group. This option takes effect
on MLDv2 snooping devices.
vlan vlan-id
: Specifies all IPv6 multicast groups and all IPv6 multicast sources and groups.
all
Usage guidelines
The version of MLD running on a simulated member host is the same as the version of MLD
snooping running on the port. The port ages out in the same way as a dynamic member port.
Examples
# Configure GigabitEthernet 1/0/1 as a simulated member host for the IPv6 multicast group (
FF3E::101) in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mld-snooping host-join ff3e::101 vlan 2
mld-snooping host-tracking
Use
mld-snooping host-tracking
Use
undo mld-snooping host-tracking
Syntax
mld-snooping host-tracking
undo mld-snooping host-tracking
Default
Host tracking is disabled.
Views
VLAN view
Predefined user roles
network-admin
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command for the VLAN.
You can enable host tracking for a VLAN in VLAN view or globally for all VLANs in MLD-snooping
view. For a VLAN, the VLAN-specific configuration has the same priority as the global configuration.
Examples
# In VLAN 2, enable MLD snooping, and then enable host tracking.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
: Specifies a VLAN by its VLAN ID in the range of 1 to 4094.
: Specifies an IPv6 multicast source by its IPv6 address. If
to enable host tracking for a VLAN.
to disable host tracking for a VLAN.
35
,
*