H3C IE4300 Command Reference Manual page 1526

Predefined user roles
network-admin
Parameters
ip-address
Usage guidelines
You must enable IGMP snooping for a VLAN before you execute this command.
Examples
# In VLAN 2, enable IGMP snooping, and specify 10.1.1.1 as the source IP address of IGMP general
queries.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping general-query source-ip 10.1.1.1
Related commands
(IGMP-snooping view)
enable
igmp-snooping enable
igmp-snooping group-limit
Use
igmp-snooping group-limit
can join.
Use undo igmp-snooping group-limit
multicast groups that a port can join.
Syntax
igmp-snooping group-limit limit [ vlan vlan-list ]
undo igmp-snooping group-limit [ vlan vlan-list ]
Default
No limit is placed on the maximum number of multicast groups that a port can join.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
: Specifies the maximum number of multicast groups that a port can join, in the range of 0 to
limit
4294967295.
vlan vlan-list
VLAN by its ID or a range of VLANs in the form of
ID is in the range of 1 to 4094. If you do not specify a VLAN, this command takes effect on all VLANs.
: Specifies the source IP address for IGMP general queries.
: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a
to set the maximum number of multicast groups that a port
to remove the limit on the maximum number of
start-vlan-id to end-vlan-id
30
. The VLAN