Parameters
group group-address
multicast group, this command displays information about all Layer 2 IP multicast groups.
source source-address
multicast source, this command displays information about Layer 2 IP multicast groups for all
multicast sources.
vlan vlan-id
VLAN, this command displays information about Layer 2 IP multicast groups for all VLANs.
slot slot-number
member device, this command displays information about Layer 2 IP multicast groups for the master
device.
Examples
# Display information about Layer 2 IP multicast groups for VLAN 2.
<Sysname> display l2-multicast ip vlan 2
Total 1 entries.
VLAN 2: Total 1 entries.
(0.0.0.0, 224.1.1.1)
Attribute: static, success
Host ports (1 in total):
GE1/0/1
Table 9 Command output
Field
Total 1 entries
VLAN 2: Total 1 entries
(0.0.0.0, 224.1.1.1)
Attribute
Host ports (1 in total)
(S, SUC)
: Specifies a multicast group by its IP address. If you do not specify a
: Specifies a multicast source by its IP address. If you do not specify a
: Specifies a VLAN by its VLAN ID in the range of 1 to 4094. If you do not specify a
: Specifies an IRF member device by its member ID. If you do not specify a
Description
Total number of Layer 2 IP multicast groups.
Total number of Layer 2 IP multicast groups in VLAN 2.
(S, G) entry, where 0.0.0.0 in the S position means all multicast sources.
Entry attribute:
•
dynamic—The entry is created by a dynamic protocol.
•
static—The entry is created by a static protocol.
•
pim—The entry is created by PIM.
•
kernel—The entry is obtained from the kernel.
•
success—Processing has succeeded.
•
fail—Processing has failed.
Member ports and total number of member ports.
Port attribute:
•
D—Dynamic port.
•
S—Static port.
•
P—PIM port.
•
K—Port obtained from the kernel.
•
R—Port learned from (*, *) entries.
•
W—Port learned from (*, G) entries.
•
SUC—Processing has succeeded.
•
F—Processing has failed.
(S, SUC)
13