H3C IE4300 Command Reference Manual page 1478

: Specifies the deny match mode for the routing policy node. If a route matches all the
deny
if-match
does not match any
: Specifies the permit match mode for the routing policy node. If a route matches all the
permit
if-match
match any
if-match
node node-number
number is matched first.
Usage guidelines
Use a routing policy to filter routing information. A routing policy can contain several nodes and each
node contains a set of
criteria of the node and the
criteria. The relation between the
clauses must be met. The relation between nodes is logical OR. A packet passing a node passes the
routing policy. If a packet does not pass any nodes, the packet does not pass the routing policy.
Examples
# Create node 10 in permit mode for routing policy policy1 and enter routing policy node view.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10]
Related commands
display route-policy
route-policy-change delay-time
Use
route-policy-change delay-time
Use
undo route-policy-change delay-time
Syntax
route-policy-change delay-time { time-value | unlimited }
undo route-policy-change delay-time
Default
Routing policy changes immediately take effect, but the routing protocol waits five seconds before
processing routes from the new routing policy.
Views
System view
Predefined user roles
network-admin
Parameters
time-value
When this delay timer expires, the routing protocol waits five seconds before processing routes from
the new routing policy.
unlimited
clauses of the node, it is denied without being compared with the next node. If a route
clauses of the node, the route is compared with the next node.
if-match
clauses of the node, it is handled by the
clauses of the node, the route is compared with the next node.
: Specifies a node number in the range of 0 to 65535. A node with a smaller
if-match
apply
: Specifies the routing policy change delay timer in the range of 60 to 3600 seconds.
: Sets an infinite delay timer.
apply
and clauses. The
apply
clauses define the actions to be taken on packets matching the
clauses of a node is logical AND. All the
if-match
to set the routing policy change delay timer.
to restore the default.
9
clauses of the node. If a route does not
clauses define the match
if-match
if-match