H3C IE4300 Command Reference Manual page 1462

Policy based routing information for interface Vlan-inerface2:
Policy name: aaa
node 0 deny(not support):
Matched: 0
node 1 permit:
if-match acl 3999
Matched: 0
node 2 permit(no resource):
if-match acl 2000
apply next-hop 1000::1
Matched: 0
node 5 permit:
if-match acl 3101
apply next-hop 1000::1
Matched: 0 (no statistics resource)
Total matched: 0
Table 2 Command output
Field
Policy based routing information
for interface XXXX (failed)
node 0 deny(not support)
node 2 permit(no resource)
if-match acl
apply next-hop
Matched: 0 (no statistics resource)
Description
IPv6 PBR configuration and statistics on the interface.
This field displays failed in brackets if none of the nodes in the policy
has been successfully issued to the driver. The failed status will persist
even after the policy is successfully issued. To clear the failed status,
you must remove the policy from the interface and then apply it on the
interface again.
NOTE:
The failed status is available on a per-slot basis. To obtain this
information, you must specify a slot number when you execute the
command.
•
For a global interface (for example, a VLAN interface), which
might have member physical interfaces on multiple slots, specify
a slot that contains its member interfaces.
•
For a physical interface, specify its slot number.
Match mode of the node, permit or deny.
If a node fails to be issued to the driver, the command displays the
cause in brackets, which include:
•
not support—The device does not support the match criteria
configured on the node.
•
no resource—No sufficient resources (for example, ACLs) are
available for the node.
NOTE:
The cause is available only on a per-slot basis. To obtain this
information, you must specify a slot number when you execute the
command.
•
For a global interface (for example, a VLAN interface), which
might have member physical interfaces on multiple slots, specify
a slot that contains its member interfaces.
•
For a physical interface, specify its slot number.
Compares IPv6 packets with the IPv6 ACL.
Specifies a next hop for permitted IPv6 packets.
Number of successful matches on the node. If the device does not
4