To avoid mistakenly deleting IPv6 multicast group members, set the aging timer for dynamic member
ports to be greater than the value calculated by using the following formula:
MLD general query interval
[
As a best practice, set the aging timer of dynamic member ports to the value calculated by using the
following formula:
MLD general query interval
[
Examples
# In VLAN 2, enable MLD snooping, and set the aging timer for dynamic member ports in the VLAN
to 300 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping host-aging-time 300
Related commands
(MLD-snooping view)
enable
host-aging-time
mld-snooping enable
mld-snooping host-join
Use
mld-snooping host-join
multicast group or an IPv6 multicast source and group.
Use
undo mld-snooping host-join
for an IPv6 multicast group.
Syntax
mld-snooping
ipv6-source-address ] vlan vlan-id
undo
mld-snooping
ipv6-source-address ] vlan vlan-id | all }
Default
A port is not a simulated member host of any IPv6 multicast groups or any IPv6 multicast sources
and groups.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
ipv6-group-address
argument is FFxy::/16 (excluding FFx1::/16 and FFx2::/16), where "x" and "y" represent any
hexadecimal numbers in the range of 0 to F.
+
maximum response time for MLD general queries
]
[
× 2 +
maximum response time for MLD general queries
]
[
(MLD-snooping view)
to configure a port as a simulated member host for an IPv6
to remove the configuration of a simulated member host
host-join
host-join
: Specifies an IPv6 multicast group address. The value range for this
34
ipv6-group-address
{
ipv6-group-address
]
]
[
source-ip
[
source-ip