H3C IE4300 Command Reference Manual page 1585

# Display detailed information about dynamic router ports for VLAN 2.
<Sysname> display mld-snooping router-port vlan 2 verbose
VLAN 2:
Router slots (0 in total):
Router ports (2 in total):
GE1/0/1
GE1/0/2
Table 9 Command output
Field
VLAN 2
Router slots (0 in total)
Router ports (2 in total)
(00:01:30)
Related commands
reset mld-snooping router-port
display mld-snooping static-group
Use display mld-snooping static
group entries.
Syntax
display
ipv6-source-address ] * [ vlan vlan-id ] [ verbose ] [ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
ipv6-group-address
for this argument is FFxy::/16 (excluding FFx1::/16 and FFx2::/16), where "x" and "y" represent any
hexadecimal numbers in the range of 0 to F. If you do not specify an IPv6 multicast group, this
command displays information about static MLD snooping group entries for all IPv6 multicast
groups.
ipv6-source-address
specify an IPv6 multicast source, this command displays information about static MLD snooping
group entries for all IPv6 multicast sources.
Description
VLAN ID.
Member IDs and total number of the member devices that have dynamic
router ports, except for the specified member device or the master device
when no member device is specified.
Dynamic router ports and total number of dynamic router ports.
Remaining aging time for the dynamic router port.
This field is always displayed for a global port (including Layer 2 aggregate
interfaces).
For a non-global port, this field is displayed when one of the following
conditions exists:
•
The port is on the specified member device.
•
The port is on the master device and no member device is specified.
mld-snooping
: Specifies an IPv6 multicast group by its IPv6 address. The value range
: Specifies an IPv6 multicast source by its IPv6 address. If you do not
(00:01:30)
(00:00:23)
- group to display information about static MLD snooping
-
static group [
13
ipv6-group-address |