Rip Metricin - H3C IE4300 Command Reference Manual

•
For MD5 authentication (with packet format defined in RFC 2082), the maximum length of RIP
packets must be no less than 72 bytes.
If the configured value in the
interface, the interface MTU value is used as the maximum length of RIP packets.
Examples
# Set the maximum length of RIP packets on VLAN-interface 10 to 1024 bytes.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip max-packet-length 1024

rip metricin

Use
rip metricin
Use
undo rip metricin
Syntax
rip metricin [ route-policy route-policy-name ] value
undo rip metricin
Default
The additional metric of an inbound route is 0.
Views
Interface view
Predefined user roles
network-admin
Parameters
route-policy route-policy-name
string of 1 to 63 characters. If you specify this option, the command adds an additional metric for the
routes that match the routing policy.
value : Adds an additional metric to inbound routes, in the range of 0 to 16.
Usage guidelines
When a valid RIP route is received, the system adds a metric to it and then installs it into the routing
table. The metric of the route received on the configured interface is then increased. If the sum of the
additional metric and the original metric is greater than 16, the metric of the route will be 16.
If a routing policy is referenced with the
performed:
•
Routes matching the policy are added with the metric specified in the
configured in the policy. Routes not matching it are added with the metric specified in the
metricin
keyword in the
•
If the
apply cost
with the metric specified in the
Examples
# Configure VLAN-interface 10 to add a metric of 6 to the inbound route 1.0.0.0/8 and to add a metric
of 2 to other inbound routes.
<Sysname> system-view
rip max-packet-length
to configure an interface to add a metric to inbound routes.
to restore the default.
command. The
rip metricin
command to add or reduce a metric.
apply cost
command is not configured in the policy, all the inbound routes are added
rip metricin
command is greater than the MTU of an
: Specifies a routing policy by its name, a case sensitive
keyword, the following operations can be
route-policy
command does not support specifying the
command.
29
command
apply cost
rip
or
+ –