H3C IE4300 Command Reference Manual page 1574

Field
(1::6, FF1E::2)
Protocol
VLAN
Flag
Status
Ingress port
List of 1 egress ports
Related commands
reset ipv6 l2-multicast fast-forwarding cache all
display ipv6 l2-multicast ip
Use
display ipv6 l2-multicast ip
groups.
Syntax
display
ipv6-source-address ] * [ vlan vlan-id ] [ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
group ipv6-group-address
not specify an IPv6 multicast group, this command displays information about all Layer 2 IPv6
multicast groups.
source ipv6-source-address
do not specify an IPv6 multicast source, this command displays information about Layer 2 IPv6
multicast groups for all IPv6 multicast sources.
Description
(S, G) entry in the Layer 2 IPv6 multicast fast forwarding table.
Protocol number.
VLAN ID.
Flag for the (S, G) entry or the outgoing port.
This field displays one flag or the sum of multiple flags. In this example, the
value 0x2 means that the entry has only one flag 0x2.
The following flags are available for an entry:
•
•
The following flags are available for an outgoing interface:
•
•
•
•
Status of the (S, G) entry or the outgoing port:
•
•
Incoming port of the (S, G) entry.
List of outgoing ports of the (S, G) entry.
ipv6 l2-multicast
: Specifies an IPv6 multicast group by its IPv6 address. If you do
0x1—The entry is created because of packets passed through
between cards.
0x2—The entry is added by multicast forwarding.
0x1—The port is added to the entry because of packets passed
through between cards.
0x2—The port is added to an existing entry.
0x10—The port is associated with the entry.
0x20—The port is to be deleted.
Enabled—Available.
Disabled—Unavailable.
to display information about Layer 2 IPv6 multicast
ip [ group ipv6-group-address
: Specifies an IPv6 multicast source by its IPv6 address. If you
2
| source