H3C IE4300 Command Reference Manual page 1443

Usage guidelines
The shorter the hello interval is, the faster the topology converges and the more resources are
consumed. Make sure the hello interval on two neighboring interfaces is the same.
Examples
# Set the hello interval to 20 seconds for VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer hello 20
Related commands
ospfv3 timer dead
ospfv3 timer poll
Use
ospfv3 timer poll
Use
undo ospfv3 timer poll
Syntax
ospfv3 timer poll seconds [ instance instance-id ]
undo ospfv3 timer poll [ instance instance-id ]
Default
The poll interval is 120 seconds on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
: Specifies the poll interval in the range of 1 to 65535 seconds.
seconds
instance instance-id
default is 0.
Usage guidelines
When an NBMA interface finds its neighbor is down, it sends hello packets at the poll interval.
The poll interval must be a minimum of four times the hello interval.
Examples
# Set the poll interval on VLAN-interface 10 to 120 seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer poll 120
Related commands
ospfv3 timer hello
ospfv3 timer retransmit
Use
ospfv3 timer retransmit
to set the poll interval on an NBMA interface.
to remove the configuration.
: Specifies an interface instance by its ID in the range of 0 to 255. The
to set the LSA retransmission interval for an interface.
74