H3C IE4300 Command Reference Manual page 1617

Parameters
ipv6-address
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command.
Examples
# In VLAN 2, enable MLD snooping, and specify FE80:0:0:1::1 as the source IPv6 address of MLD
multicast-address-specific queries.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping special-query source-ip fe80:0:0:1::1
Related commands
enable (MLD-snooping view)
mld-snooping enable
mld-snooping static-group
Use
mld-snooping static-group
multicast group or an IPv6 multicast source and group.
Use
undo mld-snooping static-group
Syntax
mld-snooping
ipv6-source-address ] vlan vlan-id
undo mld-snooping
ipv6-source-address ] vlan vlan-id | all }
Default
A port is not a static member port of IPv6 multicast groups.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
ipv6-group-address
argument is FFxy::/16 (excluding FFx1::/16 and FFx2::/16), where "x" and "y" represent any
hexadecimal numbers in the range of 0 to F.
source-ip ipv6-source-address
you specify an IPv6 multicast source, this command configures the port as a static member port of an
IPv6 multicast source and group. If you do not specify an IPv6 multicast source, this command
configures the port as a static member port of an IPv6 multicast group. This option takes effect on
MLDv2 snooping devices.
vlan vlan-id
: Specifies the source IPv6 address for MLD multicast-address-specific queries.
static-group
static-group
: Specifies an IPv6 multicast group address. The value range for this
: Specifies a VLAN by its VLAN ID in the range of 1 to 4094.
to configure a port as a static member port of an IPv6
to delete the configuration of static member ports.
ipv6-group-address
{ ipv6-group-address
: Specifies an IPv6 multicast source by its IPv6 address. If
45
[ source-ip
[ source-ip