H3C IE4300 Command Reference Manual page 1237

Interface: 172.16.0.1 (Vlan-interface10)
Cost: 1 State: DR
Priority: 1
Designated router: 172.16.0.1
Backup designated router: 0.0.0.0
Timers: Hello 10, Dead 40, Poll
FRR backup: Enabled
Primary path detection mode: BFD ctrl
Enabled by interface configuration (including secondary IP addresses)
BFD: echo
MD5 authentication enabled.
The last key is 3.
The rollover is in progress, 2 neighbor(s) left.
LDP state: No-LDP
LDP sync state: Achieved
Packet size: 1000
Table 18 Command output
Field
Interface
Timers
Transmit Delay
FRR backup
Primary path detection mode
Enabled by interface
configuration (including
secondary IP addresses)
BFD
Simple authentication
enabled
MD5 authentication enabled
The last key is xx
The rollover is in progress,
xx neighbor(s) left.
LDP state
Type: Broadcast
40, Retransmit 5, Transmit Delay 1
Description
Information about the interface, such as the IP address.
OSPF timers (in seconds): Hello, Dead, Poll, and Retransmit.
LSA transmission delay on the interface, in seconds.
Whether LFA calculation is enabled on an interface.
Primary link detection mode:
•
BFD ctrl—BFD control packet mode.
•
BFD echo—BFD echo packet mode.
OSPF is enabled on the interface (including secondary IP addresses).
BFD session mode enabled on the interface:
•
ctrl—BFD control packet mode.
•
echo—BFD echo packet mode.
Simple authentication is enabled.
MD5/HMAC-MD5 authentication is enabled.
The most recent MD5/HMAC-MD5 authentication key ID is xx.
Key rollover for MD5/HMAC-MD5 authentication is in progress. The number
of neighbors that have not completed rollover is xx.
LDP state:
•
Init—Initialization state. LDP has not been delivered.
•
No-LDP—LDP is not configured.
•
Not ready—LDP sessions have not been established.
•
Ready—LDP sessions have been established.
36
MTU: 1500