H3C IE4300 Command Reference Manual page 1537

Usage guidelines
You must enable IGMP snooping for a VLAN before you execute this command.
To avoid mistakenly deleting multicast group members, set the IGMP general query interval to be
greater than the maximum response time for IGMP general queries.
Examples
# In VLAN 2, enable IGMP snooping, and set the IGMP general query interval to 20 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping query-interval 20
Related commands
(IGMP-snooping view)
enable
igmp-snooping enable
igmp-snooping max-response-time
igmp-snooping querier
max-response-time
igmp-snooping report source-ip
Use igmp-snooping report source-ip
Use
undo igmp-snooping report source-ip
Syntax
igmp-snooping report source-ip ip-address
undo igmp-snooping report source-ip
Default
In a VLAN, the source IP address of IGMP reports is the IP address of the current VLAN interface. If
the current VLAN interface does not have an IP address, the source IP address is 0.0.0.0.
Views
VLAN view
Predefined user roles
network-admin
Parameters
ip-address
Usage guidelines
You must enable IGMP snooping for a VLAN before you execute this command.
Examples
# In VLAN 2, enable IGMP snooping, and specify 10.1.1.1 as the source IP address of IGMP reports.
<Sysname> system-view
[Sysname] igmp-snooping
: Specifies the source IP address for IGMP reports.
to configure the source IP address for IGMP reports.
to restore the default.
41