Asbr-Summary (Ospfv3 View) - H3C IE4300 Command Reference Manual

Syntax
area area-id
undo area area-id
Default
No OSPFv3 areas exist.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
: Specifies an area by its ID, an IPv4 address or a decimal integer in the range of 0 to
area-id
4294967295 that is translated into the IPv4 address format.
Examples
# Create OSPFv3 Area 0 and enter its view.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 0
[Sysname-ospfv3-1-area-0.0.0.0]

asbr-summary (OSPFv3 view)

Use
asbr-summary
Use
undo asbr-summary
Syntax
asbr-summary ipv6-address prefix-length [ cost cost-value | not-advertise
| nssa-only | tag tag ] *
undo asbr-summary ipv6-address prefix-length
Default
Route summarization is not configured on an ASBR.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
ipv6-address
prefix-length
cost cost-value
do not specify this option, the largest cost among the summarized routes applies. If the routes in
Type-5 LSAs translated from Type-7 LSAs are Type-2 external routes, the largest cost among the
summarized routes plus 1 applies.
not-advertise
command advertises the route.
to configure route summarization on an ASBR.
to remove the configuration.
: Specifies the destination IPv6 address of the summary route.
: Specifies the prefix length in the range of 0 to 128.
: Specifies the cost of the summary route, in the range of 1 to 16777214. If you
: Disables advertising the summary route. If you do not specify this keyword, the
2