H3C IE4300 Command Reference Manual page 1614

Predefined user roles
network-admin
Parameters
ipv6-address
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command.
Examples
# In VLAN 2, enable MLD snooping, and specify FE80:0:0:1::1 as the source IPv6 address for MLD
reports.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping report source-ip fe80:0:0:1::1
Related commands
(MLD-snooping view)
enable
mld-snooping enable
mld-snooping router-aging-time
Use
mld-snooping router-aging-time
VLAN.
Use
undo mld-snooping router-aging-time
Syntax
mld-snooping router-aging-time seconds
undo mld-snooping router-aging-time
Default
The aging timer for dynamic router ports is 260 seconds.
Views
VLAN view
Predefined user roles
network-admin
Parameters
: Specifies an aging timer for dynamic router ports, in the range of 1 to 8097894 seconds.
seconds
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command.
You can set the timer for a VLAN in VLAN view or globally for all VLANs in MLD-snooping view. For
a VLAN, the VLAN-specific configuration takes priority over the global configuration.
Examples
# In VLAN 2, enable MLD snooping, and set the aging timer for dynamic router ports in the VLAN to
100 seconds.
: Specifies the source IPv6 address for MLD reports.
to set the aging timer for dynamic router ports in a
to restore the default.
42