H3C IE4300 Command Reference Manual page 1528

To match the following IGMP reports, set the
source-wildcard
IGMPv1 and IGMPv2 reports.

IGMPv3 IS_EX and IGMPv3 TO_EX reports that do not carry multicast source addresses.

•
If the
vpn-instance vpn-instance
effect. If the
applies to both VPN packets and non-VPN packets.
•
Among the other optional parameters, only the
time-range-name
You can configure different ACLs on a port for different VLANs. If you configure multiple ACLs on a
port for the same VLAN, the most recent configuration takes effect.
Examples
# On GigabitEthernet 1/0/1, configure a multicast group policy for VLAN 2 so that hosts in VLAN 2
can join only multicast group 225.1.1.1.
<Sysname> system-view
[Sysname] acl basic 2000
[Sysname-acl-ipv4-basic-2000] rule permit source 225.1.1.1 0
[Sysname-acl-ipv4-basic-2000] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] igmp-snooping group-policy 2000 vlan 2
Related commands
group-policy
igmp-snooping host-aging-time
Use igmp-snooping host-aging-time
VLAN.
Use
undo igmp-snooping host-aging-time
Syntax
igmp-snooping host-aging-time seconds
undo igmp-snooping host-aging-time
Default
The aging timer for dynamic member ports is 260 seconds.
Views
VLAN view
Predefined user roles
network-admin
Parameters
: Specifies an aging timer for dynamic member ports, in the range of 1 to 8097894
seconds
seconds.
Usage guidelines
You must enable IGMP snooping for a VLAN before you execute this command.
option to 0.0.0.0:
vpn-instance vpn-instance
option take effect.
(IGMP-snooping view)
source source-address
option is specified in the rule, the rule does not take
option is not specified in the rule, the rule
keyword and the
fragment
to set the aging timer for dynamic member ports in a
to restore the default.
32
time-range