H3C IE4300 Command Reference Manual page 1605

To match MLDv1 reports and MLD IS_EX and MLDv2 TO_EX reports that do not carry IPv6
multicast source addresses, set the
0::0.
•
If the
vpn-instance vpn-instance
effect. If the
applies to both VPN packets and non-VPN packets.
•
Among the other optional parameters, only the
time-range-name
You can configure different ACLs for different VLANs on a port. If you configure multiple ACLs for the
same VLANs on a port, the most recent configuration takes effect.
Examples
# On GigabitEthernet 1/0/1, configure an IPv6 multicast group policy for VLAN 2 so that hosts
attached to the port in VLAN 2 can join only the group FF03::101.
<Sysname> system-view
[Sysname] acl ipv6 basic 2000
[Sysname-acl-ipv6-basic-2000] rule permit source ff03::101 128
[Sysname-acl-ipv6-basic-2000] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mld-snooping group-policy 2000 vlan 2
Related commands
group-policy
mld-snooping host-aging-time
Use
mld-snooping host-aging-time
VLAN.
Use
undo mld-snooping host-aging-time
Syntax
mld-snooping host-aging-time seconds
undo mld-snooping host-aging-time
Default
The aging timer for dynamic member ports is 260 seconds.
Views
VLAN view
Predefined user roles
network-admin
Parameters
: Specifies an aging timer for dynamic member ports, in the range of 1 to 8097894
seconds
seconds.
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command.
You can set the timer for a VLAN in VLAN view or globally for all VLANs in MLD-snooping view. For
a VLAN, the VLAN-specific configuration takes priority over the global configuration.
vpn-instance vpn-instance
option take effect.
(MLD-snooping view)
source source-address source-prefix
option is specified in the rule, the rule does not take
option is not specified in the rule, the rule
fragment
to set the aging timer for dynamic member ports in a
to restore the default.
33
keyword and the
time-range
option to