H3C IE4300 Command Reference Manual page 1613

Default
The MLD general query interval is 125 seconds.
Views
VLAN view
Predefined user roles
network-admin
Parameters
interval
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command for the VLAN.
To avoid mistakenly deleting IPv6 multicast group members, set the MLD general query interval to be
greater than the maximum response time for MLD general queries.
Examples
# In VLAN 2, enable MLD snooping, and set the MLD general query interval to 20 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping query-interval 20
Related commands
(MLD-snooping view)
enable
max-response-time
mld-snooping enable
mld-snooping max-response-time
mld-snooping querier
mld-snooping report source-ip
Use
mld-snooping report source-ip
Use
undo mld-snooping report source-ip
Syntax
mld-snooping report source-ip ipv6-address
undo mld-snooping report source-ip
Default
In a VLAN, the source IPv6 address for MLD reports is the IPv6 link-local address of the current
VLAN interface. If the current VLAN interface does not have an IPv6 link-local address, the source
IPv6 address is FE80::02FF:FFFF:FE00:0001.
Views
VLAN view
: Specifies an MLD general query interval, in the range of 2 to 31744 seconds.
to configure the source IPv6 address for MLD reports.
to restore the default.
41