H3C IE4300 Command Reference Manual page 1751

[Sysname-GigabitEthernet1/0/1] qos wrr 0 group 1 weight 10
Related commands
display qos queue wrr interface
qos wrr
qos wrr group sp
Use
qos wrr group sp
Use
undo qos wrr group sp
Syntax
qos wrr queue-id group sp
undo qos wrr queue-id
Default
All queues on a WRR-enabled interface are in WRR group 1.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
queue-id
Table 18.
Usage guidelines
This command is available only on a WRR-enabled interface. Queues in the SP group are scheduled
with SP. The SP group has higher scheduling priority than the WRR groups.
You must use the
command on an interface.
A queue in the SP group is not scheduled if the queue has the lowest priority among all queues with
traffic load on the interface.
Examples
# Enable WRR queuing on GigabitEthernet 1/0/1, and assign queue 0 to the SP group.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wrr weight
[Sysname-GigabitEthernet1/0/1] qos wrr 0 group sp
Related commands
display qos queue wrr interface
qos wrr
to assign a queue to the SP group.
: Specifies a queue by its ID. The value range for this argument is 0 to 7 or keywords in
qos wrr command to enable WRR queuing before you can configure this
to remove a queue from the SP group.
44