H3C IE4300 Command Reference Manual page 1662

IPv6 MCE commands
This chapter describes only IPv6 MCE-specific commands. For information about the commands
available for both IPv4 MCE and IPv6 MCE, see
address-family ipv6 (VPN instance view)
Use
address-family ipv6
Use
undo address-family ipv6
family view.
Syntax
address-family ipv6
undo address-family ipv6
Views
VPN instance view
Predefined user roles
network-admin
Usage guidelines
In VPN instance IPv6 address family view, you can configure IPv6 VPN parameters such as inbound
and outbound routing policies.
Examples
# Enter VPN instance IPv6 address family view.
<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] address-family ipv6
[Sysname-vpn-ipv6-vpn1]
Related commands
address-family ipv4
vpn-instance-capability simple (OSPFv3 view)
Use vpn-instance-capability simple
process.
Use undo vpn-instance-capability
process.
Syntax
vpn-instance-capability simple
undo vpn-instance-capability
Default
Routing loop detection is enabled for a VPN OSPFv3 process.
Views
OSPFv3 view
"MCE
to enter VPN instance IPv6 address family view.
to remove all configurations from VPN instance IPv6 address
(VPN instance view)
to disable routing loop detection for a VPN OSPFv3
to enable routing loop detection for a VPN OSPFv3
1
commands."