H3C IE4300 Command Reference Manual page 1532

igmp-snooping leave source-ip
Use
igmp-snooping leave source-ip
messages.
Use
undo igmp-snooping leave source-ip
Syntax
igmp-snooping leave source-ip ip-address
undo igmp-snooping leave source-ip
Default
In a VLAN, the source IP address of IGMP leave messages is the IP address of the current VLAN
interface. If the current VLAN interface does not have an IP address, the source IP address is
0.0.0.0.
Views
VLAN view
Predefined user roles
network-admin
Parameters
ip-address
Usage guidelines
You must enable IGMP snooping for a VLAN before you execute this command.
Examples
# In VLAN 2, enable IGMP snooping, and specify 10.1.1.1 as the source IP address of IGMP leave
messages.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping leave source-ip 10.1.1.1
Related commands
(IGMP-snooping view)
enable
igmp-snooping enable
igmp-snooping max-response-time
Use
igmp-snooping max-response-time
general queries in a VLAN.
Use
undo igmp-snooping max-response-time
Syntax
igmp-snooping max-response-time seconds
undo igmp-snooping max-response-time
: Specifies the source IP address for IGMP leave messages.
to configure the source IP address for IGMP leave
to restore the default.
to set the maximum response time for IGMP
to restore the default.
36