H3C IE4300 Command Reference Manual page 1711

Option
service-dot1p
dot1p-value&<1-8
service-vlan-id vlan-id-list
source-mac mac-address
[ mac-address-mask ]
Usage guidelines
In a traffic class with the logical OR operator, you can configure multiple
any of the available match criteria.
When you configure a match criterion that can have multiple values in one
follow these restrictions and guidelines:
•
You can specify up to eight values for any of the following match criteria in one
command:
802.1p priority.

DSCP.

VLAN ID.

•
If a packet matches one of the specified values, it matches the
•
To delete a criterion that has multiple values, the specified values in the
command must be the same as those specified in the
values can be different.
When you configure ACL-based match criteria, follow these restrictions and guidelines:
•
The ACL must already exist.
•
The ACL is used for classification only and the permit/deny actions in ACL rules are ignored.
Actions taken on matching packets are defined in traffic behaviors.
You can use both AND and OR operators to define the match relationships between the criteria for a
class. For example, you can define relationships among three match criteria in traffic class
as follows:
traffic classifier classB operator and
if-match criterion 1
if-match criterion 2
traffic classifier classA operator or
if-match criterion 3
Examples
# Define a match criterion for traffic class class1 to match the packets with a destination MAC
address of 0050-ba27-bed3.
Description
Matches 802.1p priority values in outer VLAN tags.
The
>
space-separated list of up to eight 802.1p priority values.
The value range for the
Matches VLAN IDs in outer VLAN tags.
The
space-separated list of up to 10 VLAN items. Each item
specifies a VLAN or a range of VLANs in the form of
vlan-id1 to vlan-id2
must be greater than or equal to the value for
The value range for the
You can use this option to match single-tagged packets
typically except for the nesting (outer VLAN tag adding)
action.
Matches a source MAC address.
This option takes effect only on Ethernet interfaces.
4
dot1p-value&<1-8>
dot1p-value
vlan-id-list
argument specifies a
vlan-id
if-match
if-match
argument specifies a
argument is 0 to 7.
vlan-id2
. The value for
vlan-id1
argument is 1 to 4094.
commands for
if-match
command,
if-match
if-match
command.
undo if-match
command. The order of the
classA
.