Show Trapflags; Snmp-Server Community - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

show trapflags

This command displays trap conditions. Configure which traps the switch should generate by
enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected,
the switch's SNMP agent sends the trap to all enabled trap receivers. The switch does not have to
be reset to implement the changes. Cold and warm start traps are always generated and cannot be
disabled.
Format
Mode
Authentication Flag
Link Up/Down Flag
Multiple Users Flag
Spanning Tree Flag
Broadcast Storm Flag
DVMRP Traps
OSPF Traps
PIM Traps

snmp-server community

This command adds (and names) a new SNMP community. A community name is a name
associated with the switch and with a set of SNMP managers that manage it with a specified
privileged level. The length of name can be up to 16 case-sensitive characters.
Note: Community names in the SNMP community table must be unique. When making multiple
entries using the same community name, the first entry is kept and processed and all duplicate
entries are ignored.
Switching Commands
show trapflags
Privileged EXEC
May be enabled or disabled. The factory default is enabled. Indicates
whether authentication failure traps will be sent.
May be enabled or disabled. The factory default is enabled. Indicates
whether link status traps will be sent.
May be enabled or disabled. The factory default is enabled. Indicates
whether a trap will be sent when the same user ID is logged into the
switch more than once at the same time (either via telnet or serial port).
May be enabled or disabled. The factory default is enabled. Indicates
whether spanning tree traps will be sent.
May be enabled or disabled. The factory default is enabled. Indicates
whether broadcast storm traps will be sent.
May be enabled or disabled. The factory default is disabled. Indicates
whether DVMRP traps will be sent.
May be enabled or disabled. The factory default is disabled. Indicates
whether OSPF traps will be sent.
May be enabled or disabled. The factory default is disabled. Indicates
whether PIM traps will be sent.
202-10102-01, May 2005
8-27