Secure Shell (Ssh) Commands; Show Telnetcon; Ip Ssh - NETGEAR GSM7228PS Cli Manual

show telnetcon

This command displays the current inbound Telnet settings. In other words, these settings apply to
Telnet connections initiated from a remote system to the switch.
Format
show telnetcon
Modes • Privileged EXEC
• User EXEC
Term Definition
Remote This object indicates the number of minutes a remote connection session is allowed to
Connection
remain inactive before being logged off. May be specified as a number from 1 to 160. The
Login Timeout
factory default is 5.
(minutes)
Maximum This object indicates the number of simultaneous remote connection sessions allowed.
Number of
The factory default is 5.
Remote
Connection
Sessions
Allow New Telnet New Telnet sessions will not be allowed when this field is set to no. The factory default
Sessions
value is yes.

Secure Shell (SSH) Commands

This section describes the commands you use to configure SSH access to the switch. Use SSH to
access the switch from a remote management host.
Note: The system allows a maximum of 5 SSH sessions.

ip ssh

Use this command to enable SSH access to the system. (This command is the short form of the ip
ssh server enable command.)
Default disabled
Management Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
10-16