Classofservice Dot1P-Mapping; Classofservice Ip-Precedence-Mapping - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static

13.1.1 classofservice dot1p-mapping

This command maps an 802.1p priority to an internal traffic class. The
and
<trafficclass>
available traffic classes depends on the platform. For more information about 802.1p
priority, see Section 6.3 "Provisioning (IEEE 802.1p) Commands" on page
Format
Modes
13.1.1.1 no classofservice dot1p-mapping
This command maps an 802.1p priority to a default internal traffic class value.
Format
Modes

13.1.2 classofservice ip-precedence-mapping

This command maps an IP precedence value to an internal traffic class. The
precedence>
number of available traffic classes depends on the platform.
Format
Modes
13.1.2.1 no classofservice ip-precedence-mapping
This command maps an IP precedence value to a default internal traffic class value
Format
Modes
13-2
values can both range from 0-7, although the actual number of
classofservice dot1p-mapping <userpriority> <traf-
ficclass>
Global Config
Interface Config
no classofservice dot1p-mapping
Global Config
Interface Config
and
<trafficclass>
classofservice ip-precedence-mapping <ip-prece-
dence> <trafficclass>
Global Config
Interface Config
no classofservice ip-precedence-mapping
Global Config
Interface Config
v1.0, November 2007
values can both range from 0-7, although the actual
Quality of Service (QoS) Commands
<userpriority>
6-14.
<ip-