Show classofservice ip-precedence Mapping
The example is shown as CLI commands and as a Web interface procedure.
CLI: Showing classofservice ip-precedence Mapping
(Netgear Switch) #show classofservice ip-precedence-mapping
IP Precedence
Traffic Class
-------------
-------------
0
1
2
3
4
5
6
7
Web Interface: Showing classofservice ip-precedence Mapping
To use the Web interface to show CoS trust mode, proceed as follows:
1.
From the main menu, select QoS > Advanced >IP Precedence Queue Mapping. A screen similar to the
following displays.
Figure 13-3
2.
Select the All from the Interface pull-down menu.
3.
The global IP precedence to Queue mapping is displayed.
4.
Select the specific interface(e.g. 1/0/1) from the Interface pull-down menu.
Class of Service (CoS) Queuing
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
1
0
0
1
2
2
3
3
v1.0, November 2008
13-5