Encapsulation - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Format
Mode
14.2.8.1 no ip mtu
This command resets the ip mtu to the default value.
Format
Mode

14.2.9 encapsulation

This command configures the link layer encapsulation type for the packet. Acceptable
values for
<encapstype>
Format
Mode
Note: Routed frames are always ethernet encapsulated when a frame is routed to
Routing Commands
ip mtu <mtu>
Interface Config
no ip mtu <mtu>
Interface Config
are ethernet and SNAP. The default is ethernet.
encapsulation {ethernet | snap}
Interface Config
a VLAN.
v4.1, October 2008
14-11