Show Spanning-Tree Summary; Show Spanning-Tree Interface - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Bridge Max Hops
Bridge Hello Time
Bridge Forward Delay
Bridge Hold Time

show spanning-tree summary

This command displays spanning tree settings and parameters for the switch. The following details
are displayed on execution of the command.
Format
Modes
Spanning Tree Adminmode
Spanning Tree Version
Configuration Name
Configuration Revision Level
Configuration Digest Key
MST Instances

show spanning-tree interface

This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The <slot/port> is the desired switch port. The following details are
displayed on execution of the command.
Format
Mode
Hello Time
Port mode
Switching Commands
Bridge max-hops count for the device.
Configured value.
Configured value.
Minimum time between transmission of Configuration Bridge Protocol
Data Units (BPDUs)
show spanning-tree summary
Privileged EXEC
User EXEC
Enabled or disabled.
Version of 802.1 currently supported (IEEE 802.1s, IEEE 802.1w, or
IEEE 802.1d) based upon the Force Protocol Version parameter.
Identifier used to identify the configuration currently being used.
Identifier used to identify the configuration currently being
used.
Identifier used to identify the configuration currently being used.
List of all multiple spanning tree instances configured on the switch
show spanning-tree interface <slot/port>
Privileged EXEC
User EXEC
Admin hello time for this port.
Enabled or disabled
.
202-10102-01, May 2005
8-129