Show Spanning-Tree Interface - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Configuration
Revision Level
Configuration
Digest Key
MST Instances

5.2.3 show spanning-tree interface

This command displays the settings and parameters for a specific switch port within the
common and internal spanning tree. The
following details are displayed on execution of the command.
Format
Modes
Hello Time
Port mode
Port Up Time
Since Counters
Last Cleared
STP BPDUs
Transmitted
STP BPDUs
Received
RST BPDUs
Transmitted
RST BPDUs
Received
MSTP BPDUs
Transmitted
Spanning Tree Protocol Commands
Identifier used to identify the configuration currently being
used.
Identifier used to identify the configuration currently being
used.
List of all multiple spanning tree instances configured on the
switch
<slot/port>
show spanning-tree interface <slot/port>
Privileged EXEC
User EXEC
Admin hello time for this port.
Enabled or disabled.
Time since port was reset, displayed in days, hours, minutes,
and seconds.
Spanning Tree Protocol Bridge Protocol Data Units sent
Spanning Tree Protocol Bridge Protocol Data Units received.
Rapid Spanning Tree Protocol Bridge Protocol Data Units
sent
Rapid Spanning Tree Protocol Bridge Protocol Data Units
received.
Multiple Spanning Tree Protocol Bridge Protocol Data Units
sent
v1.0, February 2007
is the desired switch port. The
5-13