Spanning-Tree Configuration Revision; No Spanning-Tree Configuration Revision; Spanning-Tree Edgeport; No Spanning-Tree Edgeport - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

spanning-tree configuration revision

This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision Level is a
number in the range of 0 to 65535.
Default
Format
Mode

no spanning-tree configuration revision

This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value, i.e. 0.
Format
Mode

spanning-tree edgeport

This command specifies that this port is an Edge Port within the common and internal spanning
tree. This will allow this port to transition to Forwarding State without delay.
Format
Mode

no spanning-tree edgeport

This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format
Mode

spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value. The Force Protocol
Version can be one of the following:
Switching Commands
0
spanning-tree configuration revision <0-65535>
Global Config
no spanning-tree configuration revision
Global Config
spanning-tree edgeport
Interface Config
no spanning-tree edgeport
Interface Config
December 2004, 202-10010-02
8-83