Set Igmp Groupmembershipinterval; No Set Igmp Groupmembershipinterval; Set Igmp Interfacemode All; No Set Igmp Interfacemode All - NETGEAR ProSafe GSM7224 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

set igmp groupmembershipinterval

This command sets the IGMP Group Membership Interval time on the system. The Group
Membership Interval time is the amount of time in seconds that a switch will wait for a report from
a particular group on a particular interface before deleting the interface from the entry. This value
must be greater than the IGMP Maximum Response time value. The range is 1 to 3600 seconds.
Default
Format
Mode

no set igmp groupmembershipinterval

This command sets the IGMP Group Membership Interval time on the system to 260 seconds.
Format
Mode

set igmp interfacemode all

This command enables IGMP Snooping on all interfaces. If an interface which has IGMP
Snooping enabled is enabled for routing or is enlisted as a member of a port-channel (LAG),
IGMP Snooping functionality will be disabled on that interface. IGMP Snooping functionality will
subsequently be re-enabled if routing is disabled or port-channel (LAG) membership is removed
from an interface that has IGMP Snooping enabled.
Default
Format
Mode

no set igmp interfacemode all

This command disables IGMP Snooping on all interfaces.
Format
Mode
8-50
260 seconds
set igmp groupmembershipinterval <1-3600>
Global Config
no set igmp groupmembershipinterval
Global Config
Disabled
set igmp interfacemode all
Global Config
no set igmp interfacemode all
Global Config
202-10009-01_060204
Switching Commands