Set Garp Timer Leave; No Set Garp Timer Leave; Set Garp Timer Leave All; No Set Garp Timer Leave All - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Mode

set garp timer leave

This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be
considered a buffer time for another station to assert registration for the same attribute in order to
maintain uninterrupted service.time is 20 to 600 (centiseconds). The value 60 centiseconds is 0.6
seconds.
Note:
This command has an effect only when GVRP is enabled.
Default
Format
Mode

no set garp timer leave

This command sets the GVRP leave time per port to 60 centiseconds (0.6 seconds).
Note:
This command has an effect only when GVRP is enabled.
Format
Mode

set garp timer leave all

This command sets the GVRP leave time for all ports. Leave time is the time to wait after
receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry.
This can be considered a buffer time for another station to assert registration for the same attribute
in order to maintain uninterrupted service.time is 20 to 600 (centiseconds). The value 60
centiseconds is 0.6 seconds.
Note:
This command has an effect only when GVRP is enabled.
Default
Format
Mode

no set garp timer leave all

This command sets the GVRP leave time for all ports to the default 60 centiseconds (0.6 seconds).
Switching Commands
Global Config
60
set garp timer leave <20-600>
Interface Config
no set garp timer leave
Interface Config
60
set garp timer leave all <20-600>
Global Config
202-10102-01, May 2005
8-101