Set Garp Timer Leave - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

8.1.2 set garp timer leave

This command sets the GVRP leave time. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This
can be considered a buffer time for another station to assert registration for the same
attribute in order to maintain uninterrupted service.time is 20 to 600 (centiseconds). The
value 60 centiseconds is 0.6 seconds.
Note: This command has an effect only when GVRP is enabled.
Default
Format
Modes
8.1.2.1 no set garp timer leave
This command sets the GVRP leave time to the default.
Note: This command has an effect only when GVRP is enabled.
Format
Modes
GARP, GVRP, and GMRP Commands
60
set garp timer leave <20-600>
Interface Config
Global Config
no set garp timer leave
Interface Config
Global Config
v1.0, February 2007
8-3